Hand Crafted Woodworking
The objective today was to fix the problem on the tail vise mounting stock. I realized yesterday as I was writing the notes for Day 26 pictures there was a problem with the mounting bolts for the tail vise stock. The sliding nut assemblies were engineered as two aluminum pieces so the bolt could move […]
The objectives today are to finish the twin vise and tail vise installations. Twin Vise All that remains for the twin vise is to mill a 2″ front vise face. This is required so that I can mark the shaft center holes on the vise front face without have to do very intense measurements […]
The object today was supposed to be finishing the tenons and short rails. In order to do that I needed an exact understanding of the relationship if the vises to the legs. The twin will has an control shaft that connects the two locking mechanisms. This will pass over one of the upper short […]
The objective for today is routing out the tail vise slot and complete the glue up of the forth section of the top. That will be the last section. Built a jig to allow routing the template slot. This is being done on the side of the top piece. It uses the same router setups […]
