Hand Crafted Woodworking
We are getting to the end. Today is finishing installing the twin vise and the shelf boards. The twin vise installation for hardware had been completed with the bench up-side down. This enabled me to do precision work will all of the hardware alignment, mounting the vise back boards and drilling the various […]
The objectives today are to finish the twin vise and tail vise installations. Twin Vise All that remains for the twin vise is to mill a 2″ front vise face. This is required so that I can mark the shaft center holes on the vise front face without have to do very intense measurements […]
Objective today is complete the short rails mortise and tenons for for 2nd set of legs. Start installation of twin vise including cutting clearance in upper rail, sizing and initial fitting of backer boards for twin vise. Completing the remaining mortise and tenons for the short rails was straight forward. Learned a lot on […]
The object today was supposed to be finishing the tenons and short rails. In order to do that I needed an exact understanding of the relationship if the vises to the legs. The twin will has an control shaft that connects the two locking mechanisms. This will pass over one of the upper short […]
